Word counter
Count words, characters, sentences and reading time.
- 1Upload
- 2Settings
- 3Download
How to use Word counter
About Word counter
Counting words, characters and sentences helps you meet limits for essays, social posts, meta descriptions, subject lines, abstracts and application forms. As you type or paste, the counts update instantly, and the reading-time estimate shows how long the text takes to read.
Limits are not always measured the same way. Some forms count characters with spaces, others without, and a few count bytes. A tweet-sized limit is measured in characters, an essay in words. As a rule of thumb, search results show roughly 155–160 characters of a description, and a typical page of double-spaced text holds about 250–300 words.
How it works: paste or type text and the counts update as you go: words, characters with and without spaces, sentences, paragraphs and an estimated reading time. The text is analysed in your browser as you type and is not stored or sent anywhere.
Step by step: 1) paste your draft into the box; 2) read the live figures; 3) edit until you hit your target; 4) copy the text back out. Counting is based on whitespace-separated words, which matches how most word processors and submission forms count.
Realistic limits: different systems count slightly differently. Hyphenated words, numbers, URLs and emojis can be treated differently by an application form, a search engine snippet tool or a word processor, so leave a small safety margin when you are near a hard limit. Reading time is an estimate based on an average adult reading pace, not a measurement of your audience.
Typical uses: keeping an essay or personal statement inside a word limit, trimming a meta description to a character limit, checking a social post, estimating how long a speech or blog post will take, or confirming a translation job length before quoting.
Using the numbers well: for essays and applications, count the words but also read the finished text aloud once; length limits are a ceiling, not a goal. For search and social snippets, characters matter more than words, because titles and descriptions are cut off by pixel width, so keep key information near the start. A reading time near two or three minutes suits a short article, while a speech is usually timed at about 130 spoken words a minute, slower than the silent reading estimate.
Editing technique: write freely first, then count, then cut. Remove repeated phrases, filler such as "very" and "really", and long introductions. If you need to shorten by ten percent, start with the longest paragraph, since that is where wordiness hides. Paste the edited version back to confirm you are under the limit.
Tips for better results
- Paste your text and check both the word and character counts, with and without spaces.
- Reading time assumes an average adult pace of around 200–250 words per minute.
- Count after you finish editing, since formatting and line breaks can change totals.
- To measure text inside a PDF, extract it first with PDF to text.
- Check both limits if a form states characters and words separately.
- Remove extra spaces and blank lines first for a cleaner paragraph count.
- Aim a few words under the limit to allow for counting differences.